Справочник Пользователя для State Industries SUF-60-120

64

Tank

Sediment 

Removal

Semi Annually

Flushing

Tank

Lime Scale 

Removal

Semi Annually

UN-LImE®

Anode rods

inspection 

Cleaning

Annually

Clean Scale 

Deposits

T&P Valve

Test operation

Semi Annually

Test

Vent System

inspection

Annually

Termination 

Screens Clean

Reseal/Repair

it is recommended that the water heater storage tank be drained 

and  flushed  every  6  months  to  reduce  sediment  buildup.  The 

water heater should be drained if being shut down during freezing 

temperatures. See Features And Components on page 7 for the 

location of the water heater components described below.

Burn harzard.

Hot water discharge.

Keep  hands   clear  of  drain

valve  discharge.

to drain the water heater storage tank:
1.  Turn off the electrical supply to the water heater.
2.  Turn off the gas supply at the main Gas Shutoff Valve if the 

water heater is going to be shut down for an extended period. 

3.  Ensure the cold water inlet valve is open.
4.  Open a nearby hot water faucet and let the water run until the 

water is no longer hot.

5.  Connect a hose to the water heater drain valve and terminate 

it to an adequate drain.

6.  Close the cold water inlet valve.
7.  Open the water heater drain valve and allow all the water to 

drain from the storage tank.

8.  Close  the  water  heater  drain  valve  when  all  water  in  the 

storage tank has drained.

9.  Close the hot water faucet opened in Step 4.
10. if the water heater is going to be shut down for an extended 

period, the drain valve should be left open.

to flush the tank perform the following steps:
1.  Turn off the electrical supply to the water heater.
2.  Ensure the cold water inlet valve is open.
3.  Open a nearby hot water faucet and let the water run until 

the water is no longer hot. Then close the hot water faucet.

4.  Connect  a  hose  to  the  drain  valve  and  terminate  it  to  an 

adequate drain.

keep appliance area clear and free from combustible materials, 

gasoline and other flammable vapors and liquids. See Locating 

The Water Heater on page 12.
Water  heater  maintenance  includes  periodic  tank  flushing  and 

cleaning, and removal of lime scale. The water heater should be 

inspected and adjusted to maintain proper combustion. See initial 

Start Up on page 52. A periodic inspection of the venting system 

should be made. Where used, water circulating pump(s) should 

be oiled according to the pump manufacturers recommendations.
precautions

Flooding at or above the level of the burner or controls.

External damage.

Firing without water.

Sooting.

Do not operate the water heater until all corrective steps

have been made by a qualified service agent.

Never  operate  the  water  heater  without  first  being  certain  it  is 

filled  with  water  and  a  properly  sized  and  rated  Temperature-

Pressure relief Valve is installed in the relief valve opening on 

the  water  heater.  See  Temperature-Pressure  relief  Valve  on 

Overheated water can cause

water tank explosion.

Properly sized temperature and

pressure relief valve must be

installed in the opening provided.

Should overheating occur or the gas supply fail to shut off, turn of 

the main Gas Shutoff valve. See Figure 52 on page 39.
Water  heater  maintenance  includes  periodic  tank  flushing  and 

cleaning, and removal of lime scale. The water heater should be 

inspected and adjusted to maintain proper combustion. refer to 

the following table. A periodic inspection of the venting system 

should be made. Where used, the water circulating pump should 

be oiled according to the pump manufacturer's recommendations.