Справочник Пользователя для Rheem HP50RH
The chart shown above may be used as a guide
in determining the proper water temperature for your
home.
!
DANGER: Households with small children, disabled,
or elderly persons may require a 120°F or lower thermostat
setting to prevent contact with “HOT” water.
The temperature of the water in the heater is regulated
by the water heater interface control. To comply with
safety regulations the temperature was set at 122°F
before the water heater was shipped from the factory.
The illustration at the
left shows the water
temperature setting.
Refer to the
Refer to the
Operating Instructions
in this manual for
detailed instructions
in how to adjust the
water temperature.
!
DANGER:
Hotter water increases the potential for Hot
Water SCALDS
.
Time/Temperature Relationship in Scalds
Temperature
Time To Produce a Serious Burn
120°F (49°C)
More than 5 minutes
125°F (52°C)
1½ to 2 minutes
130°F (54°C)
About 30 seconds
135°F (57°C)
About 10 seconds
140°F (60°C)
Less than 5 seconds
145°F (63°C)
Less than 3 seconds
150°F (65°C)
About 1½ seconds
155°F (68°C)
About 1 second
Table courtesy of Shriners Burn Institute
D A N G E R
!
HOT
Water temperature over 125
°F can
cause severe burns instantly or
death from scalds.
Children, disabled and elderly are
at highest risk of being scalded.
See instruction manual before
setting temperature at water
heater.
Feel water before bathing or
Feel water before bathing or
showering.
Temperature limiting valves are
Temperature limiting valves are
available, see manual.
BURN
IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
3
DANGER!
WATER TEMPERATURE SETTING
Safety and energy conservation are factors to be considered when selecting the water
temperature setting of water heater. Water temperatures above 125°F can cause severe
burns or death from scalding. Be sure to read and follow the warnings outlined on the
label pictured below. This label is also located on the water heater near the thermistor
access panel.
NOTICE: Mixing valves are available for reducing point
of use water temperature by mixing hot and cold water
in branch water lines. Contact a licensed plumber or the
local plumbing authority for further information.
TEMPERATURE
SETTING
HEAT PUMP OFF
Review operating manual before use.
Operating procedures are outlined in the
manual for optimal performance.
OPERATION MODE
RISK OF SCALDING INCREASES
WITH HOTTER WATER
CAUTION
Hotter
Water
Cooler
Water
Temperatures
135°-140° F
130°-135° F
125°-130° F
120°-125° F
105°-120° F
130°-135° F
125°-130° F
120°-125° F
105°-120° F
90°-105° F