Справочник Пользователя для Rheem 260 Litre

19 

These conditions may result in either water at a temperature exceeding the 
requirements of AS/NZS 3500.4 being delivered to the hot water outlets in the 
ablution areas, or the device closing completely and not delivering water at all, 
or the device failing. Under either condition, the operation and performance of 
the device cannot be guaranteed. 
 

 

 

 
REDUCING HEAT LOSSES 
The cold water line to and the hot water line from the water heater must be 
insulated in accordance with the requirements of AS/NZS 

3500.4. The 

insulation must be weatherproof and UV resistant if exposed. 
 
ANODE TYPES 
The correct anode type for the water supply being used must be fitted in the 
water heater (refer to 

“Water Supplies”

 on page 38). The black anode is fitted 

as standard. 
 

Total Dissolved Solids in water supply to the water heater 

Anode colour code 

0 – 40 mg/L 

Green 

40 – 600 mg/L 

Black 

600 – 2500 mg/L 

Blue 

 
SADDLING - PIPE WORK 
To prevent damage to the cylinder when attaching pipe clips or saddles to the 
water heater jacket, we recommend the use of self-drilling screws with a 
maximum length of 12 mm. Should pre drilling be required, extreme caution 
must be observed when penetrating the jacket of the water heater. 
Note: Damage to the cylinder as a result of saddling to the jacket will void 
the warranty.