Справочник Пользователя для Sterling Water Heater

 

(Available online at www.sterlco.com) 

 

Part No:  682.92594.10 

(Refer to main manual for complete installation instructions). 
 

1.  Connect 3-phase power based on nameplate data. 
2.  Install properly sized plumbing between temperature control unit 

and primary processing equipment (supply and return).  

3.  Install properly sized plumbing between temperature control unit 

and cooling water supply and return. Cooling water supply must be 
at least 16 psi (110 kPa/1.1bar) for a 250˚F (121°C)

 

configuration 

and 55 psi (379 kPa/3.8bar) for a 300˚F (149°C) configuration.  

4.  Ensure proper pump rotation. (The pump should be moving 

clockwise while looking at the motor end). 

 
 

 
 

(Refer to main manual and controller manual for complete operating instructions). 
 

1. Push 

the 

ON/OFF rocker switch to the ON ( | ) to energize the unit and begin the temperature control cycle. 

The switch will be illuminated whenever the unit is on.  

2.  The unit will automatically vent for approximately one minute. 
3.  If needed, press and hold the vent button to purge any additional air from the process loop. 
 
4.  Set process temperature (PV) by pressing the         Up Arrow or         Down Arrow keys.  

1.  Adjust set point below 150˚ F (66˚ C). 

Allow unit to stabilize. 

2.  Push ON/OFF rocker switch to the OFF               

( 0 ) position to de-energize the unit.