Справочник Пользователя для Dantax LR-6500
- 4 -
Before Use
Before Connection
CAUTION
Turn off the power of all the equipment before mak-
ing connections.
Read instructions of each component you intend to
use with this unit.
ing connections.
Read instructions of each component you intend to
use with this unit.
< Be sure to insert each plug securely. To prevent
hum and noise, do not bundle the connection
cords with the power cord or speaker cord.
cords with the power cord or speaker cord.
Back-up Memory Function
This is the function which preserves the preset mem-
ory and most-recent memory functions. In the event
of a power failure, or if the power cord of this unit is
disconnected from the electric outlet, the back-up
memory will preserve the preset memory and most-
recent memory functions for as long as approximate-
ly 15 days.
ory and most-recent memory functions. In the event
of a power failure, or if the power cord of this unit is
disconnected from the electric outlet, the back-up
memory will preserve the preset memory and most-
recent memory functions for as long as approximate-
ly 15 days.
If the power supply is interrupted for 15 days or
longer, the memory settings will be erased.
longer, the memory settings will be erased.
When to Use RESET
<
When this system is subjected to an electrical
shock.
shock.
<
When the power is irregular.
In these cases, try the following
In these cases, try the following
Press the ENTER button for more than 5 seconds.
Note:
If the ENTER button is pressed for more than 5
seconds Standby mode, all the memory will be
erased.
seconds Standby mode, all the memory will be
erased.
Read this before operation
< As the unit may become warm during operation,
always leave sufficient space above the unit for ven-
tilation.
tilation.
< The voltage supplied to the unit should match the
voltage as printed on the rear panel. If you are in any
doubt regarding this matter, consult an electrician.
doubt regarding this matter, consult an electrician.
< Choose the installation location of your unit carefully.
Avoid placing it in direct sunlight or close to a source
of heat. Also avoid locations subject to vibrations
and excessive dust, heat, cold or moisture.
of heat. Also avoid locations subject to vibrations
and excessive dust, heat, cold or moisture.
< Do not open the cabinet as this might result in dam-
age to the circuitry or electrical shock. If a foreign
object should get into the set, contact your dealer.
object should get into the set, contact your dealer.
< When removing the power plug from the wall outlet,
always pull directly on the plug, never yank the cord.
< Do not attempt to clean the unit with chemical sol-
vents as this might damage the finish. Use a clean,
dry cloth.
dry cloth.
< Keep this manual in a safe place for future reference.