Справочник Пользователя для Denon ADV-700

36

Start playback on the selected component.

• For operating instructions, refer to the component’s

manual.

• The volume can be adjusted within the range of –60 to 0 to

18 dB. However, when the channel level is set as

described, if the volume for any channel is set at +1 dB or

greater, the volume cannot be adjusted up to 18 dB. (In this

case the maximum volume adjustment range is “18 dB —

(Maximum value of channel level)”.)

Either turn the MASTER VOLUME dial on the main unit or

use the VOLUME buttons on the remote control unit to

adjust the volume.

M.VOLUME -20

MASTER VOLUME

Main unit

VOLUME

Remote control unit

The volume level is displayed
on the display.

NOTE:
• The digital input indicator will light when “DIG” playing CD-

ROMs containing data other than audio signals, but no sound
will be heard.

Input mode when playing DTS sources

• Noise will be output if DTS-compatible CDs or LDs are played in

the “ANALOG” or “PCM” mode.

When playing DTS-compatible sources, be sure to connect the

source component to the digital input jacks (OPTICAL/COAXIAL)

and set the input mode to “DTS”.

• Noise may be generated at the beginning of playback and while

searching during DTS playback in the AUTO mode. If so, play in

the DTS mode.

• The “DIG” lights when digital signals are being input properly. If the

LED does not light, check whether the digital input component

setup and connections are correct and whether the component’s

power is turned on.

PRO LOGIC II

DIG

DIG

DIG

AUTO

ANA

DIG

ANA

DIG

AUTO

ANA

DIG

AUTO

ANA

DIG

AUTO

• In the AUTO mode

• In the DIGITAL PCM mode

• In the DIGITAL DTS mode

• In the ANALOG mode

One of these lights, depending on
the input signal.

Lit

One of these
lights,
depending on
the input signal.

• DOLBY DIGITAL

• DTS

• PCM

STATUS

Main unit

FUNCTION

/SELECT

Main unit

STATUS

Remote control unit

2

Cheking the currently playing program source, etc.

Either press the STATUS button on the main unit then turn

the FUNCTION / SELECT dial or press the STATUS button

on the remote control unit to check the unit’s operating

status.