Инструкции Пользователя для Brother NV1500D

Скачать
Страница из 201
LOWER/UPPER THREADING
G
ett
ing
 Read
y
25
1
e
While holding the thread from the spool in 
your right hand, hold the end of the thread 
with your left hand, and then pass the thread 
through the thread guide.
a Thread guide
f
Pass the thread under the pin on the bobbin 
winding thread guide, and then pass it around 
the pretension disk.
* Make sure that the thread passes under the pretension disk.
a Pin
b Pretension disk
g
Wind the thread clockwise around the bobbin 
four or five times.
h
Pass the end of the thread through the guide 
slit in the bobbin winder seat, and then pull 
the thread to the right to cut it with the 
cutter.
a Guide slit
b Bobbin winder seat
i
Slide the bobbin holder to the left until it 
snaps into place.
* When the bobbin holder is set to the left, it works as a 
switch to make the bobbin wind automatically.
a Bobbin holder (switch)
→ The bobbin stops spinning automatically when it is 
full, and the bobbin holder returns to its original 
position.
j
Cut the thread, and then remove the bobbin.
 CAUTION
• Be sure to follow the process described. If the thread 
is not cut with the cutter, and the bobbin is wound, 
when the thread runs low, it may tangle around the 
bobbin.
a
a
b
1
2
3
a
b
Note
When removing the bobbin, pull up only on the bobbin. 
Do not pull on the bobbin winder seat, otherwise it may 
become loose, resulting in damage to the machine.
 CAUTION
• Setting the bobbin improperly may cause the thread 
tension to loosen, breaking the needle and possibly 
resulting in injury.
a