Инструкции Пользователя для Brother NX 600
APPENDIX
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
142
GETTING READ
Y
CONTENTS
SEWING BASICS
U
T
IL
IT
Y
S
T
ITCHES
APPENDIX
INDEX
Troubleshooting
If the machine stops operating correctly, check the following possible problems before requesting service.
If the problem persists, contact your retailer or the nearest authorized service center.
If the problem persists, contact your retailer or the nearest authorized service center.
Symptom
Probable Cause
Remedy
Reference
The sewing
machine does not
operate.
The machine is not turned on.
Turn on the machine.
The start/stop button was not
pressed.
pressed.
Press the start/stop button.
The presser foot lever is raised.
Lower the presser foot lever.
–
The start/stop button was pressed,
even though the foot controller is
connected.
even though the foot controller is
connected.
Do not use the start/stop button
when the foot controller is
connected. To use the start/stop
button, disconnect the foot
controller.
when the foot controller is
connected. To use the start/stop
button, disconnect the foot
controller.
The needle breaks.
The needle is incorrectly installed.
Correctly install the needle.
The needle clamp screw is loose.
Use the screwdriver to firmly
tighten the screw.
tighten the screw.
The needle is bent or blunt.
Replace the needle.
The combination of fabric, thread
and needle is not correct.
and needle is not correct.
Select a thread and needle that
are appropriate for the type of
fabric being sewn.
are appropriate for the type of
fabric being sewn.
The presser foot that is used is not
appropriate for the type of stitch that
you wish to sew.
appropriate for the type of stitch that
you wish to sew.
Attach the presser foot that is
appropriate for the type of stitch
that you wish to sew.
appropriate for the type of stitch
that you wish to sew.
The upper thread tension is too tight. Loosen the upper thread tension.
The fabric is pulled too much.
Lightly guide the fabric.
–
The spool is incorrectly installed.
Correctly install the spool.
The area around the hole in the
needle plate is scratched, or has a
burr on it.
needle plate is scratched, or has a
burr on it.
Replace the needle plate. Contact
your retailer or the nearest
authorized service center.
your retailer or the nearest
authorized service center.
–
The area around the hole in the
presser foot is scratched, or has a
burr on it.
presser foot is scratched, or has a
burr on it.
Replace the presser foot. Contact
your retailer or the nearest
authorized service center.
your retailer or the nearest
authorized service center.
–
The shuttle is scratched, or has a burr
on it.
on it.
Replace the shuttle. Contact your
retailer or the nearest authorized
service center.
retailer or the nearest authorized
service center.
–
A bobbin designed specifically for
this machine is not used.
this machine is not used.
Incorrect bobbins will not work
properly. Only use a bobbin
designed specifically for this
machine.
properly. Only use a bobbin
designed specifically for this
machine.