Справочник Пользователя для Brother Embroidery and Sewing Machine
BEFORE EMBROIDERING
B-62
g
Hold the embroidery foot in place with
your right hand, and then use the included
screwdriver to securely tighten the presser
foot holder screw.
your right hand, and then use the included
screwdriver to securely tighten the presser
foot holder screw.
h
Plug the connector of the embroidery foot
“W+” with LED pointer into the jack on the
back of your machine.
“W+” with LED pointer into the jack on the
back of your machine.
i
Press
to unlock all keys and
buttons.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.
■ Checking the Needle Drop Point
With the Embroidery Foot “W+”
with LED Pointer
with LED Pointer
Before beginning to embroider when using the
embroidery foot “W+” with LED pointer, carefully
read the procedures described in the “Embroidery”
and “Embroidery Edit” chapters.
embroidery foot “W+” with LED pointer, carefully
read the procedures described in the “Embroidery”
and “Embroidery Edit” chapters.
a
After the embroidery frame is attached,
press
in the embroidery screen.
→ The LED pointer indicates the needle drop point.
*
The LED pointer turns off automatically by lowering
the presser foot or returning to the previous page.
the presser foot or returning to the previous page.
CAUTION
• Use the included screwdriver to firmly tighten
the screw of the embroidery foot. If the screw
is loose, the needle may strike the presser foot
and possibly cause injury.
is loose, the needle may strike the presser foot
and possibly cause injury.
Memo
• When the LED pointer is turned on, the
presser foot height is automatically adjusted
according to the fabric thickness.
according to the fabric thickness.
• If
is pressed again, the fabric thickness
is remeasured and the presser foot is set to
the optimum height.
the optimum height.
Note
• With thick elastic fabric, the position will be
misaligned only at raised parts in the fabric.
In this case, manually adjust the position
according to the thickness of the fabric.
In this case, manually adjust the position
according to the thickness of the fabric.
• With fabric that has a very uneven surface
such as quilting, the position is not correctly
aligned. In this case, the pointer indication
should be used only as a reference.
aligned. In this case, the pointer indication
should be used only as a reference.