Справочник Пользователя для Brother BE-438B

4. ASSEMBLY

４-８. Upper shaft mechanism

Push the thread trimmer
cam onto the upper shaft
crank, align the forward set
screw in the rotation
direction with the screw
stop position, and tighten
the set screw at that
position.

Rotation direction

<KE-435B, 435C>

<KE-436B, 436C>

3380Q

Apply grease.

Apply adhesive (Threebond
1401 or similar) to the outside
of the bearing.

Upper shaft bush

KE-430B, 430C series

Make a gap of 1.0 mm between
the magnet of timing pulley
assembly U and the syn-
chronizer assembly, and then
align the rear set screw in the
rotation direction of timing pulley
assembly U with the screw stop
position and tighten the set
screw at that position.

Rotation direction

3382Q

3383Q

Place the thread take-up crank onto the upper
shaft from the face plate end, tighten the
screw into the hole in the upper shaft, and
then tighten the set screw.

Place the thread take-up crank, thrust
washer and bobbin winder pulley
(stepping foot connecting rod) into the
upper shaft bush so that there is no play
in the parts, and then tighten the set
screw at the screw stop position.

1. Upper shaft
2. Thread trimmer cam
3. Bobbin winder pulley
<3> Stepping foot

connecting rod

4. Thrust washer

3381Q

5. Thread take-up crank
6. Screw
7. Set screw
8. Set screws [2 pcs]
<8> Set screws [2 pcs]
9. Set screws [2 pcs
10. Synchronizer assy
11. Screws [2 pcs]
12. Timing pulley assy, U
13. Set screws [2 pcs]