Справочник Пользователя для Brother GETTING READY SEWING BASICS UTILITY STITCHES
SEWING BASICS ———————————————————————————————————————————————————————————————————————————————————————————————————————
52
Sewing hook-and-loop
fastener
fastener
Note
● Before start sewing, baste together the fabric
and the hook-and-loop fastener.
Make sure that the needle passes through the hook-
and-loop fastener by turning the handwheel and
lower the needle into the hook-and-loop fastener
before sewing. And then, sew the edge of the hook-
and-loop fastener at a slow speed.
If the needle does not pass through the hook-and-
loop fastener, replace the needle with the needle for
thick fabrics (page 30).
and-loop fastener by turning the handwheel and
lower the needle into the hook-and-loop fastener
before sewing. And then, sew the edge of the hook-
and-loop fastener at a slow speed.
If the needle does not pass through the hook-and-
loop fastener, replace the needle with the needle for
thick fabrics (page 30).
a Edge of the hook-and-loop fastener
Pulling up the bobbin thread
When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.
first pull up the bobbin thread as described below.
a
Insert the bobbin into the bobbin case.
• Refer to steps
a
through
d
of “Installing
the bobbin” (page 18).
b
Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
Do not cut the thread with the cutter.
c
While lightly holding the upper thread with
your left hand with the needle in the up-
position, press
your left hand with the needle in the up-
position, press
(needle position button)
twice to lower and raise the needle.
a Needle position button
X
The bobbin thread is looped around the
upper thread and can be pulled up.
upper thread and can be pulled up.
d
Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
out the end of the bobbin thread.
e
Pull out about 10 cm (4 inches) of the bobbin
thread under the presser foot toward the rear
of the machine.
thread under the presser foot toward the rear
of the machine.
f
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover (A), and then lightly press down
on the right side (B).
Insert the tab in the lower-left corner of the
bobbin cover (A), and then lightly press down
on the right side (B).
● Use only the ungummed hook-and-loop
fastener which is for sewing. If the glue is
attached to the needle or the bobbin hook
race, it may cause malfunction.
attached to the needle or the bobbin hook
race, it may cause malfunction.
● If the hook-and-loop fastener is sewn with the
thin needle (65/9-75/11), the needle may
bend or break.
bend or break.
CAUTION
1
A
A
B