Краткое Руководство По Установке для Brother 885V95

GETTING READY

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Note

z When sewing with fine, cross-wound thread,

use the small spool cap, and leave a small
space between the cap and the spool.

a Spool cap (small)
b Spool (cross-wound thread)
c Space

z When using thread that winds off quickly,

such as transparent nylon thread or metallic
thread, place the spool net over the spool
before placing the spool of thread onto the
spool pin. If the spool net is too long, fold it
to fit the size of the spool.
When the spool net is used, the upper thread
tension may become tighter. Before sewing,
refer to "Adjusting the thread tension" (page
62).

a Spool net
b Spool
c Spool cap
d Spool pin

Pull the thread from the spool and pass the
thread under the hook of thread guide.

a Thread guide

Pass the thread behind the thread guide cover
and to the front.
While holding the thread near the spool with
your right hand, pull the thread with your left
hand as shown below.

a Thread guide cover

Pull the thread to the right, pass it under the
hook of the bobbin-winding thread guide, and
then wind the thread counterclockwise under
the pretension disc, pulling it in as far as
possible.

a Bobbin-winding thread guide

Make sure that the thread passes under the
pretension disk.

b Hook
c Pretension disk
d Pull it in as far as possible.