Справочник Пользователя для Brother 430C

4. ASSEMBLY 

 

４-４. Thread take-up mechanism 

 
 
 

3345Q 

 
 

Attach the spring to spring 
hooks (A) and (B). 

 
 
 
 

KE-430B, 430C series

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

3346Q 

1) Provisionally install the solenoid 

joint to the thread take-up solenoid 
with the set screws. 

2) Place the solenoid joint onto the 

thread take-up lever crank so that 
the flat surface is against the flat 
part of the thread take-up crank, 
and then install the solenoid setting 
plate to the machine head. 

Apply grease.

While pushing the solenoid joint 
in the direction of the arrow, set 
the solenoid setting plate and the 
solenoid joint so that the gap 
between them is 0.5 mm, and 
then tighten the set screws. 
* Move the solenoid joint and 

check that the thread take-up 
lever operates smoothly. If it 
does not move smoothly, it 
may damage the solenoid. If 
the movement is not smooth, 
make fine adjustments to the 
position of the solenoid setting 
plate until the thread take-up 
lever operates smoothly. 

3347Q

1. Thread take-up lever crank 
2. Plain washer 
3. Retaining ring 
4. Thread take-up lever 
5. Shoulder screws [2 pcs] 
6. Set screw [Temporarily tighten] 
7. Spring washer 
8. Plain washer 
9. Nut 
10. Solenoid joint 
11. Set screws [2 pcs] 
12. Spring 
13. Solenoid setting plate 
14. Screws [2 pcs] 

Seen from the front