Инструкции Пользователя для Brother PE-DESIGN
53
Arranging Embroidery Designs (Layout & Editing)
A
rr
a
ng
in
in
g Embr
oide
ry
D
e
e
s
igns
(
L
a
y
out
& E
d
iting)
■
Aligning embroidery patterns
1.
Select the patterns.
2.
Click Edit, then Align, then Left, Center,
Right, Top, Middle, or Bottom.
Right, Top, Middle, or Bottom.
→ The selected patterns are aligned as
shown below.
Scaling patterns
■
Scaling manually
1.
Select the pattern(s).
2.
Drag the handle to adjust the selected
pattern(s) to the desired size.
pattern(s) to the desired size.
■
Scaling numerically
1.
Select the patterns.
2.
Click Edit, then Numerical Setting, then Size.
3.
To change the width and height proportionally,
select the Maintain aspect ratio check box.
select the Maintain aspect ratio check box.
4.
Select the whether the width and height will be
set as a percentage (%) or a dimension
(millimeters or inches).
set as a percentage (%) or a dimension
(millimeters or inches).
5.
Type or select the desired width and height.
6.
To resize the selected pattern while maintaining
the original density and fill pattern, select the
Keep density and fill pattern check box.
the original density and fill pattern, select the
Keep density and fill pattern check box.
7.
Click OK.
b
Memo:
• If the
key is held down while a handle
is dragged, the pattern is enlarged or
reduced from the center of the pattern.
reduced from the center of the pattern.
• As you drag the handle, the current size is
displayed on the status bar.
Bottom
Right
Center
Left
Middle
Top
Handles
Shift
a
Note:
• Stamp settings remain independent from
the patterns that they are applied to. If a
pattern containing a stamp is edited, be
sure to check the stamp after editing is
finished.
pattern containing a stamp is edited, be
sure to check the stamp after editing is
finished.
c
• Some patterns imported from embroidery
cards cannot be scaled.
• When scaling stitch patterns, the number
of stitches remains the same, resulting in
a loss of quality. To keep density and fill
pattern of the embroidery pattern, hold
down the
a loss of quality. To keep density and fill
pattern of the embroidery pattern, hold
down the
key while scaling.
c
b
Memo:
The Keep density and fill pattern check box
is available only if stitch data is selected.
is available only if stitch data is selected.
c
Ctrl