Инструкции Пользователя для Brother 855-X06

—

Pull up the spool pin and put a spool of
thread on this pin.

While holding the thread from the spool
with your right hand, pass the thread
toward you, in the groove on the thread
guide. Then, pass the thread around the
pre-tension disk and pull the thread in
completely.

1 Pre-tension disk

CAUTION

Pass the end of the thread through the
hole on the bobbin from the inside of the
bobbin.

Put the bobbin onto the bobbin winder
shaft and slide the bobbin winder shaft to
the right. Turn the bobbin clockwise, by
hand, until the spring on the shaft slides
into the notch of the bobbin.

• Make sure to pull out 7 to 10 cm (3-4 inches)

of thread from the hole on the bobbin.

1 Spring on the shaft
2 Notch
3 7-10 cm (3

4 inches)

CAUTION

Turn on the machine.

1 Pre-tension disk

2 Bobbin winder shaft

3 Bobbin

1 Pull the thread

in completely.

●

If the spool of thread is in the wrong
place, or is set incorrectly, the thread
may tangle on the spool pin.

●

Pull the thread taut and hold the end of
the thread straight up. If the thread is too
short, not pulled taut or held at an angle,
injuries may occur when the thread is
wound around the bobbin.