Справочник Пользователя для Brother 882-W01
SEWING THE STITCHES
88
Dart Seam
a
Select
and attach presser foot “J”.
b
Sew a reverse stitch at the beginning of the
dart and then sew from the wide end to the
other end without stretching the fabric.
dart and then sew from the wide end to the
other end without stretching the fabric.
*
If automatic reinforcement stitching is preset, a
reinforcement stitch will automatically be sewn at
the beginning of sewing.
reinforcement stitch will automatically be sewn at
the beginning of sewing.
a Basting
c
Cut the thread at the end leaving 50 mm
(approx. 1-15/16 inches), and then tie both
ends together.
(approx. 1-15/16 inches), and then tie both
ends together.
*
Do not sew a reverse stitch at the end.
d
Insert the ends of the thread into the dart
with a hand sewing needle.
with a hand sewing needle.
e
Iron the dart to one side so that it is flat.
Gathering
Use on waists of skirts, sleeves of shirts, etc.
a
Select a straight stitch and attach presser
foot “J”.
foot “J”.
b
Set the stitch length to 4.0 mm (approx.
3/16 inch) and the thread tension to
approximately 2.0 (weaker tension).
3/16 inch) and the thread tension to
approximately 2.0 (weaker tension).
*
If you press
after pressing
and then
, the stitch length will be set
automatically to 4.0 mm (approx. 3/16 inch) and the
thread tension will be automatically set to 2.0.
thread tension will be automatically set to 2.0.