Справочник Пользователя для Brother 882-W01
USEFUL FUNCTIONS
72
Pivoting
If the pivot setting is selected, the machine stops
with the needle lowered (in the fabric) and the
presser foot is automatically raised to an
appropriate height when the “Start/Stop” button is
pressed. When the “Start/Stop” button is pressed
again, the presser foot is automatically lowered
and sewing continues. This function is useful for
stopping the machine to rotate the fabric.
with the needle lowered (in the fabric) and the
presser foot is automatically raised to an
appropriate height when the “Start/Stop” button is
pressed. When the “Start/Stop” button is pressed
again, the presser foot is automatically lowered
and sewing continues. This function is useful for
stopping the machine to rotate the fabric.
a
Select a stitch.
b
Press
to select the pivot setting.
o The key appears as
.
CAUTION
• When the pivot setting is selected, the
machine starts when the “Start/Stop” button is
pressed or the foot controller is pressed down
even if the presser foot has been raised. Be
sure to keep your hands and other items away
from the needle, otherwise injuries may occur.
pressed or the foot controller is pressed down
even if the presser foot has been raised. Be
sure to keep your hands and other items away
from the needle, otherwise injuries may occur.
Memo
• When the pivot setting is selected, the
height of the presser foot when sewing is
stopped can be changed according to the
stopped can be changed according to the
type of fabric being sewn. Press
to
display “Pivoting Height” on 2/7 of the set-
tings screen. Press
or
to select
one of the three heights (3.2 mm, 5.0 mm or
7.5 mm). To raise the presser foot further,
increase the setting. (Normally, 3.2 mm is
set.)
7.5 mm). To raise the presser foot further,
increase the setting. (Normally, 3.2 mm is
set.)
Note
• The “Needle Position – UP/DOWN” (3/7 of
the settings screen) must be set in the down
position
for the pivot function to be
used. When “Needle Position – UP/DOWN”
is set in the raised position,
appears
as light gray and cannot be used.
• The pivot function can only be used with
stitches where presser foot J or N is
indicated in the upper-left corner of the
indicated in the upper-left corner of the
screen. If any other stitch is selected,
appears as light gray and is not available.
• Use the “Presser Foot Lifter” button to make
sure the presser foot is lowered, and then
press the “Start/Stop” button to continue
sewing.
press the “Start/Stop” button to continue
sewing.
• If the pivot setting is selected,
and
beside “Presser Foot Height” in the settings
screen are not available and the setting
cannot be changed.
screen are not available and the setting
cannot be changed.