Справочник Пользователя для Janome MB-4
16
Winding the Bobbin
z Place the thread cone (spool of thread) on the rear
most spool pin.
Pass the thread through the thread guide A.
q Thread guide A
x Pass the thread through the upper hole and lower
hole in the thread guide B.
w Thread guide B
c Draw the thread to the front.
Hold the thread with both hands and pass the
thread firmly around and under the tension disk.
thread firmly around and under the tension disk.
e Tension disk
v Pass the thread through the hole in the bobbin
from the inside.
Put the bobbin on the bobbin winder spindle.
Put the bobbin on the bobbin winder spindle.
r Hole in the bobbin
t Bobbin winder spindle
t Bobbin winder spindle
b Push the bobbin winder stopper up against the
bobbin.
y Bobbin winder stopper
n Press the bobbin winding button while holding the
thread end.
u Bobbin winder button
m Press the bobbin winder button to stop the
machine when the bobbin has wound a few layers.
Cut the thread close to the bobbin and press the
bobbin winder button again.
Cut the thread close to the bobbin and press the
bobbin winder button again.
, When the bobbin is fully wound, the machine will
stop automatically.
Remove the bobbin from the bobbin winder
spindle.
Remove the bobbin from the bobbin winder
spindle.
. Cut the thread with the bobbin thread cutter.
i Bobbin thread cutter
z x
c
v
b
n
m
,
.
q
w
e
r
t
y
u
i