Справочник Пользователя для Plantronics W710

Talk time performance is
significantly degraded even after a
full recharge.

Battery is wearing out. Contact us at 

 .

I can’t hear a dial tone in the
headset.

Make sure your headset is charged.
Make sure your headset is subscribed to base. See

Press the base desk phone button.
Make sure the lifter is lifting the handset high enough to operate
the hookswitch; set to a higher setting if necessary.
Adjust the configuration switch on the base until a dial tone is
heard. The default 

Fine tune the listening volume with the headset call control
button. See

If the volume is still too low, adjust the desk phone listening
volume on the base. See

I hear static.

Make sure there is at least 12 inches between your base and your
computer, and 6 inches between your base and your telephone. If
adjusting the distance doesn’t help, your headset is going out of
range, move closer to the base. See

The sound is distorted.

Lower the desk phone speaking volume and/or desk phone
listening volume on the base. For most telephones the correct
setting is position 3. See

If your desk phone has a volume control, lower until the
distortion disappears.
If the distortion is still present, adjust the headset volume control
to lower the headset speaker volume. See

Make sure there is 12 inches between your base and your
computer, and 6 inches between your base and your telephone.
See

I hear echo in the headset.

Lower the desk phone speaking volume and/or desk phone
listening volume on the base. For most telephones the correct
setting is position 3. See

If the audio level is too low in this position, increase the headset
volume. See

If your speaking volume is too low for your listener in this
position, adjust the position of the headset to make sure the
microphone is as close as possible to your mouth.
Adjust the configuration switch on the base until a dial tone is
heard. The default 

People I talk to can hear a buzz in
the background.

Move the base further away from your phone. See

If the base power supply is plugged into a power strip, plug it
into the wall directly.

Troubleshooting

33