Справочник Пользователя для ONKYO C-S5VL

3

1.

—Unless it’s for personal use 

only, recording copyrighted material is illegal without the 
permission of the copyright holder.

2.

—The AC fuse inside the unit is not 

userserviceable. If you cannot turn on the unit, contact 
your Onkyo dealer.

3.

—Occasionally you should dust the unit all over 

with a soft cloth. For stubborn stains, use a soft cloth 
dampened with a weak solution of mild detergent and 
water. Dry the unit immediately afterwards with a clean 
cloth. Don’t use abrasive cloths, thinners, alcohol, or other 
chemical solvents, because they may damage the finish or 
remove the panel lettering.

4.

BEFORE PLUGGING IN THE UNIT FOR THE FIRST 
TIME, READ THE FOLLOWING SECTION 
CAREFULLY.
AC outlet voltages vary from country to country. Make 
sure that the voltage in your area meets the voltage 
requirements printed on the unit’s rear panel (e.g., AC 120 
V, 60 Hz or AC 100-240 V, 50/60 Hz).
The power cord plug is used to disconnect this unit from 
the AC power source. Make sure that the plug is readily 
operable (easily accessible) at all times.
Pressing the [POWER] button to select OFF mode does 
not fully shutdown the unit. If you do not intend to use the 
unit for an extended period, remove the power cord from 
the AC outlet.

5.

Excessive sound pressure from earphones and headphones 
can cause hearing loss.

6.

Batteries (battery pack or batteries installed) shall not be 
exposed to excessive heat as sunshine, fire or the like.

7.

—Never 

handle this unit or its power cord while your hands are wet 
or damp. If water or any other liquid gets inside this unit, 
have it checked by your Onkyo dealer.

8.

•

If you need to transport this unit, use the original 
packaging to pack it how it was when you originally 
bought it.

•

Do not leave rubber or plastic items on this unit for a 
long time, because they may leave marks on the 
case.

•

This unit’s top and rear panels may get warm after 
prolonged use. This is normal.

•

If you do not use this unit for a long time, it may not 
work properly the next time you turn it on, so be sure 
to use it occasionally.

•

When you’ve finished using this unit, remove all 
discs and turn off the power.

9.

•

Install this unit in a well-ventilated location.

•

Ensure that there’s adequate ventilation all around 
this unit, especially if it’s installed in an audio rack. 
If the ventilation is inadequate, the unit may 
overheat, leading to malfunction.

•

Do not expose this unit to direct sunlight or heat 
sources, because its internal temperature may rise, 
shortening the life of the optical pickup.

•

Avoid damp and dusty places, and places subject to 
vibrations from loudspeakers. Never put the unit on 
top of, or directly above a loudspeaker.

•

Install this unit horizontally. Never use it on its side 
or on a sloping surface, because it may cause a 
malfunction.

•

If you install this unit near a TV, radio, or VCR, the 
picture and sound quality may be affected. If this 
occurs, move this unit away from the TV, radio, or 
VCR.

10.

Read the following carefully:
Moisture may condense on the lens of the optical pickup, 
one of the most important parts inside this unit.

•

Moisture condensation can occur in the following 
situations:
-

The unit is moved from a cold place to a warm 
place.

-

A heater is turned on, or cold air from an air 
conditioner is hitting the unit.

-

In the summer, when this unit is moved from an 
air conditioned room to a hot and humid place.

-

The unit is used in a humid place.

•

Do not use this unit when there’s the possibility of 
moisture condensation occurring. Doing so may 
damage your discs and certain parts inside this unit.

If condensation does occur, remove all discs and leave this 

unit turned on for two to three hours. By this time, the unit 
will have warmed up and any condensation will have 
evaporated.