Инструкции Для Сборки для Hans Grohe 06653XX0

3

Recommended water pressure 

14.7 - 72.5 psi

Max. water pressure 

147 psi

Recommended hot water temp. 

120� - 140� F*

Max. hot water temp 

165�F*

Hole size in mounting surface  

1 1/4” valves, 1 3/8” spout 

Max. mounting surface depth 

1 1/2”

Flow rate 

2.2 gpm

Requires 1/2” supply lines (not included)

*Please know and follow all applicable local plumbing codes when setting the temperature on the water heater.  In 

Massachusetts, the water heater may be set no higher than 112

o

F.

Install the mounting nut, metal washer and the fiber 

washer on the valve.
Insert the valve through the hole in the deck.  The 

hot valve is marked with a red dot.
Install the stop ring on the valve.  Thread the mount-

ing plate on the valve until the stop ring stops it at 

the proper height.
Rest the valve on the mounting surface.  Turn the 

valves so that the outlets point toward the center.
Tighten the mounting nut.  Tighten the tensioning 

screws.

Swing C and Limbo C only:  Place the spout, 

deco ring, and sealing ring on the mounting 

surface.
All other models:  Place the spout and sealing 

ring on the mounting surface.