Справочник Пользователя для American Standard 7055.115

Q:  How will I know if battery needs  to be replaced?
A:  Valve does not open and sensor blinks 2 times interrupted by pause for up to 7 days.

Q:  Why has the flow rate of the faucet reduced significantly?
A: Check and clean aerator and strainer.

Q:  There is no flow out of faucet when I'm in the sensor range?
A: Check sensor. If sensor blinks 2 times interrupted by pause, replace battery, or call 1 800-442-1902. 

Q:  What is the normal operating pressure range?
A:   Faucet will operate with supply pressures ranging from 20-80 psi.

7

1.  For general cleaning use a damp, soft cloth to clean 
the spout and the sensor.

2. For cleaning dirt use a soft cloth with diluted dish 
washing detergent. Wipe the area using a wet cloth 
and dry using a soft cloth.

Avoid using anything that may scratch the spout 
surface. Never use polishing power, detergent or a 
nylon scrub brush. They will damage the surface of the 
spout or Sensor.

M965255 REV. 1.6

1. Remove the FAUCET COVER (1) by unthreading the 
LEVER SCREW 

(2) and pulling off the LEVER 

HANDLE 

(3). Unthread the FAUCET COVER SCREW 

(4) at the back of the FAUCET. Pull FAUCET COVER 
(1) up and off. See Fig. 2 in this section.    

2. Replace LEVER HANDLE and rotate 
counter-clockwise to its stop position (100% cold). 
Remove HANDLE.

3. Pull out LIMITER STOP (1) from the VALVE STEM (2). 

4. Rotate LIMITER STOP (1) 180 degrees and insert 
back onto VALVE STEM 

(2).

5. Replace FAUCET COVER (1) and LEVER HANDLE 
(3). Install LEVER HANDLE SCREW (2), FAUCET 
COVER SCREW 

(4) and tighten. See Fig. 2 in this 

section.    

ROTATE 180

SLOT

SLOT