Инструкции По Обслуживанию для Toshiba MMU-AP0151MH
13
3-4. Correct Usage
When you use the air conditioner for the first time or when you change the SET DATA value, follow the proce-
dure below. From the next time, the operation displayed on the remote controller will start by pushing the
dure below. From the next time, the operation displayed on the remote controller will start by pushing the
ON / OFF
button only.
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
* After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute,
but it is not a failure.
REQUIREMENT
• While using the air conditioner, operate it only with
ON / OFF
button without turning off the main power
switch and the leak breaker.
1
Push
ON / OFF
button.
The operation lamp goes on, and the operation starts.
2
Select an operation mode with the “MODE
MODE
” button.
One push of the button, and the display
changes in the order shown on the right.
changes in the order shown on the right.
• In HEAT
mode, if the room temperature reaches to
the set temperature, the outdoor unit stops and the air
flow becomes ULTRA LOW and the air volume decreases.
flow becomes ULTRA LOW and the air volume decreases.
• In the heating mode, the fan stops so that cool air is not discharged and Heat
is displayed.
3
Select air volume with “FAN
FAN
” button.
One push of the button, and the display
changes in the order shown on the right.
changes in the order shown on the right.
• When air volume is “AUTO
”, air volume differs according to the temperature difference between set
temp. and room temp.
• In DRY
mode, “AUTO
” is displayed and the air volume is LOW.
• In heating operation, if the room temperature is not heated sufficiently with VOLUME “LOW
” operation,
select “MED.
” or “HIGH
” operation.
4
Determine the set up temperature by pushing the “TEMP.
” or “TEMP.
” button.
Stop
Push
ON / OFF
button.
The operation lamp goes off, and the operation stops.
1
3
2
4
ON / OFF
FAN
TEMP.
SWING/FIX
TIME
MODE
VENT
UNIT
SET
CL
FILTER
RESET TEST
RESET TEST
TIMER SET
Heat-pump model
DRY
COOL
FAN
Cooling only model
(Dehumidity)
AUTO
HEAT
DRY
COOL
FAN
LOW
MED.
HIGH
AUTO