Справочник Пользователя для Integra DHC-9.9
105
4
Use the Up and Down [
q]/[w] but-
tons to select “Subwoofer”, and
then use the Left and Right
[
then use the Left and Right
[
e]/[r] buttons to select:
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
5
Use the Up and Down [
q]/[w] but-
tons to select “Front”, and then
use the Left and Right [
use the Left and Right [
e]/[r]
buttons to select a crossover fre-
quency.
quency.
Note:
Fixed at “Full Band” if “Subwoofer”
(step 4) is set to “No”.
Fixed at “Full Band” if “Subwoofer”
(step 4) is set to “No”.
6
Use the Up and Down [
q]/[w] but-
tons to select “Center”, and then
use the Left and Right [
use the Left and Right [
e]/[r]
buttons to select a crossover fre-
quency.
If no center speaker is connected, select
None.
quency.
If no center speaker is connected, select
None.
Note:
Cannot select “Full Band” if “Front”
(step 5) is set to anything other than
“Full Band”.
Cannot select “Full Band” if “Front”
(step 5) is set to anything other than
“Full Band”.
7
Use the Up and Down [
q]/[w] but-
tons to select “Surround”, and
then use the Left and Right
[
then use the Left and Right
[
e]/[r] buttons to select a cross-
over frequency.
If no surround left and right speakers
are connected, select “None”.
If no surround left and right speakers
are connected, select “None”.
Note:
Cannot select “Full Band” if “Front”
(step 5) is set to anything other than
“Full Band”.
Cannot select “Full Band” if “Front”
(step 5) is set to anything other than
“Full Band”.
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
8
Use the Up and Down [
q]/[w] but-
tons to select “SurrBack”, and
then use the Left and Right
[
then use the Left and Right
[
e]/[r] buttons to select a cross-
over frequency.
If no surround back speakers are con-
nected, select “None”.
If no surround back speakers are con-
nected, select “None”.
Notes:
• Cannot be set if “Speaker Type” is
• Cannot be set if “Speaker Type” is
set to “Bi-Amp” (page 55), “Sur-
round” is set to “None” (step 7).
round” is set to “None” (step 7).
• Cannot select “Full Band” if “Sur-
round” (step 7) is set to anything
other than “Full Band”.
other than “Full Band”.
9
Use the Up and Down [
q]/[w] but-
tons to select “SurrBack Ch”,
and then use the Left and Right
[
and then use the Left and Right
[
e]/[r] buttons to select:
1ch: Select if one surround back
speaker is connected.
2ch: Select if two (left and right)
surround back speakers are
connected.
connected.
Note:
Cannot be set if “Speaker Type” is set
to “Bi-Amp” (page 55), “SurrBack” is
set to “None” (step 8).
Cannot be set if “Speaker Type” is set
to “Bi-Amp” (page 55), “SurrBack” is
set to “None” (step 8).
Continue with step 10 on the next page.
Enter
Enter
Enter
Enter