Справочник Пользователя для Integra DHC-9.9

26

This section explains how to connect the supplied indoor 
FM antenna and AM loop antenna, and how to connect 
commercially available outdoor FM and AM antennas.

The AV controller won’t pick up any radio signals 
without any antenna connected, so you must connect the 
antenna to use the tuner.

■ North American Model

■ Other Models

The supplied indoor FM antenna is for indoor use only.

If you cannot achieve good reception with the supplied 
indoor FM antenna, try a commercially available out-
door FM antenna instead (see page 27).

The supplied indoor AM loop antenna is for indoor use 
only.

■ North American Model

■ Other Models

Once your AV controller is ready for use, you’ll 
need to tune into an FM radio station and adjust 
the position of the FM antenna to achieve the best 
possible reception.

Insert the plug fully 
into the jack.

Insert the plug fully 
into the jack.

Caution: Be careful that you don’t injure yourself 
when using thumbtacks.

Connect both wires of the AM loop 
antenna to the AM push terminals, as 
shown.
(The antenna’s wires are not polarity sensitive, so 
they can be connected either way around).

Make sure that the wires are attached securely and 
that the push terminals are gripping the bare 
wires, not the insulation.

■ North American Model

Thumbtacks, etc.

Push Insert 

wire

Release