Справочник Пользователя для ONKYO TX-SR508

En

The digital input signal formats are available only for the 
input sources that you have assigned a digital input jack 
(

Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the follow-
ing issues when playing PCM or DTS material, you can 
manually set the signal format to PCM or DTS.

• If the beginnings of tracks from a PCM source are cut off, try 

setting the format to PCM.

• If noise is produced when fast forwarding or reversing a DTS 

CD, try setting the format to DTS.

• The setting is stored individually for each input selector.
• The setting will be reset to “Auto” when you change the setting 

in the “Audio Selector” (

You can adjust the bass and treble for the front speakers, 
except when the Direct, Pure Audio listening mode is 
selected.

■

■

See “Bass” and “Treble” of “Tone Control Settings” 
(

43).

• To bypass the bass and treble tone circuits, select the Direct or 

Pure Audio listening mode.

• This procedure can also be performed on the remote controller 

by using AUDIO (

43). 

e/r 

`

Auto: 

The format is detected automatically. If no dig-
ital input signal is present, the corresponding 
analog input is used instead.

`

PCM:

Only 2-channel PCM format input signals will 
be heard. If the input signal is not PCM, the 
PCM indicator will flash and noise may also be 
produced.

`

DTS:

Only DTS (but not DTS-HD) format input sig-
nals will be heard. If the input signal is not 
DTS, the DTS indicator will flash and there 
will be no sound.