Справочник Пользователя для ONKYO TX-SR503E

17

Connecting Your  Speakers—Continued

Using a suitable cable, connect the AV receiver’s SUB-
WOOFER PRE OUT to an input on your powered sub-
woofer, as shown. If your subwoofer is unpowered and 
you’re using an external amplifier, connect the SUB-
WOOFER PRE OUT to an input on the amp.

Note:
Make sure the cable is plugged all the way.

Note:
When speaker set B is turned on, speaker set A is reduced 
to 5.1-channel playback.

Strip 5/8" (15 mm) of insu-
lation from the ends of the 
speaker cables, and twist 
the bare wires tightly, as 
shown.

Unscrew the terminal. Fully insert the bare wires. 
Make sure that the bare wire is touching the inside 
of the pole. Screw the terminal tight.

5/8" (15 mm)

Strip 3/8" (10 mm) of insu-
lation from the ends of the 
speaker cables, and twist 
the bare wires tightly, as 
shown.

While pressing the lever, insert 
the wire into the hole, and then 
release the lever.
Make sure that the terminals are 
gripping the bare wires, not the 
insulation.

3/8" (10 mm)

Surround

back left 

speaker

Surround

back right 

speaker

Front left 

speaker

Front right 

speaker

Center

speaker

Surround

right

speaker

Surround

left

speaker

The following illustration shows which speaker should be 
connected to each pair of terminals.
If you’re using only one surround back speaker, connect it 
to the left (L) SURROUND BACK SPEAKERS terminals.

Front left 

speaker

Front right 

speaker

Powered

subwoofer