Справочник Пользователя для ONKYO TX-SR503E

57

Troubleshooting—Continued

The remote controller doesn’t work?
• Make sure that the batteries are installed with the cor-

rect polarity (page 9).

• Make sure that the remote controller is not too far 

away from the AV receiver, and that there’s no 
obstruction between the remote controller and the AV 
receiver’s remote control sensor (page 9).

• Make sure you’ve selected the correct remote control-

ler mode (page 10).

• Make sure you’ve entered the correct remote control 

code.

Can’t control other components?
• Make sure you’ve selected the correct remote control-

ler mode (page 10).

• If you’ve connected an 

-compatible Onkyo Mini-

Disc or CD recorder to the TAPE IN/OUT jacks, for 
the remote controller to work properly, you must set 
the display to MD or CD (see pages 31 and 53).

• The wrong remote control code has been entered.
• The entered remote control code may not be correct. If 

more than one code is listed, try each one.

• With some AV components, certain buttons may not 

work as expected, and some may not work at all.

• To control Onkyo components via 

, point the 

remote controller at the AV receiver.

• To control Onkyo components without 

, or other 

manufacturers’ components, point the remote control-
ler at that component.

Can’t record?
• On your recorder, make sure the correct input is 

selected.

• To prevent signal loops and damage to the AV 

receiver, input signals are not fed through to outputs 
with the same name (e.g., TAPE IN to TAPE OUT, or 
VIDEO 1 IN to VIDEO 1 OUT).

• When the Pure Audio listening mode is selected, 

recording is not possible because no video signals are 
output. Select another listening mode.

The sound changes when I connect my head-
phones?
• When a pair of headphones is connected, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, Direct, or Pure Audio (not North American 
model).

The display doesn’t work?
• The display is turned off when the Pure Audio (not 

North American model) listening mode is selected.

How do I change the language of a multiplex 
source?
• Use the “Multiplex” setting on the “4. Audio Adjust” 

menu to select Main or Sub (page 47).

• To use 

, you must make an 

 connection and an 

analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected digi-
tally (page 29).

The AV receiver contains a microcomputer for signal pro-
cessing and control functions. In very rare situations, 
severe interference, noise from an external source, or 
static electricity may cause it to lockup. In the unlikely 
event that this happens, unplug the power cord from the 
wall outlet, wait at least five seconds, and then plug it 
back in again.

Onkyo is not responsible for damages (such as CD 
rental fees) due to unsuccessful recordings caused by 
the unit’s malfunction. Before you record important 
data, make sure that the material will be recorded cor-
rectly.

Before disconnecting the power cord from the wall out-
let, set the AV receiver to Standby.