Справочник Пользователя для ONKYO TX-NR5010

With 

u (Remote Interactive), you can use the following 

special functions:

■

Auto Power On
When you start playback on a component connected via 
u, while the AV receiver is on standby, the AV 
receiver will automatically turn on and select that 
component as the input source.

■

Direct Change
When playback is started on a component connected via 
u, the AV receiver automatically selects that 
component as the input source.

■

System Off
When you turn off the AV receiver, the components turn 
off automatically.

■

Remote Control
You can use the AV receiver’s remote controller to 
control your other 

u-capable Onkyo components, 

pointing the remote controller at the AV receiver’s 
remote control sensor instead of the component. You 
must enter the appropriate remote control code first 
(

• Use  only 

u cables for u connections. u cables are supplied 

with Onkyo components.

• Some components have two 

u jacks. You can connect either 

one to the AV receiver. The other jack is for connecting 

additional 

u-capable components.

• Connect only Onkyo components to 

u jacks. Connecting other 

manufacturer’s components may cause a malfunction.

• Some components may not support all 

u functions. Refer to the 

manuals supplied with your Onkyo components.

• While Zone 2/3 is on, the System Off, Auto Power On and Direct 

Change 

u functions do not work.

• Turning on the AV receiver may cause a momentary power surge 

that might interfere with other electrical equipment on the same 
circuit. If this is a problem, plug the AV receiver into a different 
branch circuit.

• Do not use a power cord other than the one supplied with the AV 

receiver. The supplied power cord is designed exclusively for use 
with the AV receiver and should not be used with any other 
equipment.

• Never disconnect the power cord from the AV receiver while the 

other end is still plugged into a wall outlet. Doing so may cause 
an electric shock. Always disconnect the power cord from the 
wall outlet first, and then the AV receiver.

F

u connection (see the illustration).

e.g., cassette tape deck

RI Dock

To AC wall outlet