Справочник Пользователя для ONKYO TX-NR5010

■

`

You can select the listening modes that are grouped in 
the following categories: “MOVIE/TV”, “MUSIC”, 
“GAME”, and “THX”.

Use 

q/w to select the category and e/r to select the 

listening mode. Press ENTER to switch to the 
selected listening mode.

*1

• The video preview is not displayed when:

– HDMI IN 5/6/7/8 is the current HDMI input source, or
– No signal is present on the current input source, or
– The  “Zone 2 HDMI” setting is set to “Use” (

• The video of the currently-selected input is displayed on the 

main screen, not on a preview thumbnail.

*2

“Dolby Volume”, “Dynamic EQ” and “Dynamic Volume” 
cannot be selected when any of the THX listening modes is 
selected, with “Loudness Plus” set to “On” or “Preserve 
THX Settings” set to “Yes” (

).

*3

When “Dynamic EQ” is set to “On” or “Dynamic Volume” 
is set to anything else than “Off”, “Dolby Volume” will be 
switched to “Off” (

).

*4

• When the “Monitor Out” setting is set to “Sub”, “Video” 

cannot be selected (

• This setting cannot be used with the NET input selector.

*5

Only when you have selected “Custom” in the “Picture 
Mode” (

), pressing ENTER allows you to adjust 

the following items via the Quick Setup: “Brightness”, 
“Contrast”, “Hue” and “Saturation”. Press RETURN to 
return to the “Picture Mode” setting.

*6

Depending on the input source and listening mode, not all 
channels shown here output the sound.

*7

• This setting is not available in either of the following cases:

– The  “Audio TV Out” setting is set to “On” (

).

– “HDMI Control(RIHD)” is set to “On” (

) and 

you’re listening through your TV speakers.

You can change various audio settings from the Quick 
Setup (

• These settings are not available in either of the following cases:

– The  “Audio TV Out” setting is set to “On” (

– “HDMI Control(RIHD)” is set to “On” (

) and 

you’re listening through your TV speakers.

■

`

Stereo Source 1, Stereo Source 2, Stereo Source 3, 
Multich Source 1, Multich Source 2, Multich 
Source 3

`

Off 

With this setting, you can select the combination of 
settings that you registered in “Sound Program Edit” 
(

).

• If the input selector is changed, the “Sound Program” setting is 

switched back to “Off”.

■

`

–10dB to 0dB to +10dB in 2 dB steps.

You can boost or cut low-frequency sounds output.

■

`

–10dB to 0dB to +10dB in 2 dB steps.

You can boost or cut high-frequency sounds output.

You can adjust the bass for the front, front wide, front high, 
center, surround, surround back and subwoofer speakers 
and treble for the front, front wide, front high, center, 
surround and surround back speakers, except when the 
Direct, Pure Audio or THX listening mode is selected.

• Speakers that are set to “No” or “None” in “Speaker 

) cannot be adjusted.

• When “Sound Program” is enabled, “Subwoofer 1” and 

“Subwoofer 2” cannot be used if the “Subwoofer” setting is set 
to “No” in “Sound Program Edit” (