Справочник Пользователя для ONKYO TX-NR5010

On the “Monitor Out” settings, you can select whether or 
not to have the video sources’ images output through the 
HDMI output.
If you connect your TV to the HDMI output, the “Monitor 
Out” setting is automatically set and composite video and 
component video sources are upconverted

*

 and output.

If you connect your TV to the COMPONENT VIDEO 
MONITOR OUT (not the HDMI output), “Monitor Out” 
setting is automatically set and composite video source is 
upconverted

*

 and output.

• See “Video Connection Formats” (

) for charts 

showing how the “Monitor Out” and “Resolution” settings 
affect the video signal flow through the AV receiver.

■

`

Analog:

Select this if your TV is connected to the 
COMPONENT VIDEO MONITOR OUT or 
MONITOR OUT V.

`

Main:

Select this if your TV is connected to HDMI OUT 
MAIN.

`

Sub:

Select this if your TV is connected to HDMI OUT 
SUB.

`

Both:

Select this if your TVs are connected to HDMI OUT 
MAIN and HDMI OUT SUB. Video signals are 
output from both HDMI outputs at the resolution 
supported by both TVs.

■

`

Not Use 

`

When this setting is enabled, the TV connected to HDMI 
OUT ZONE 2 can be used as the TV of Zone 2.

• On the connected component, select the mode in which the delay 

between the video and audio does not occur much if the video 
signal delay occurs during the playback on the video component 
connected to the AV receiver.

• This setting cannot be selected if the “Monitor Out” setting is set 

to “Sub” or “Both”.

• When this setting is set to “Use”, the “11ch Playback” setting is 

fixed to “No” (

■

`

Select this to pass video through the AV receiver at 
the same resolution and with no conversion.

`

Select this to have the AV receiver automatically 
convert video at resolutions supported by your TV.

`

480p (480p/576p), 720p, 1080i:

Select the desired output resolution.

`

Select this for 1080p output and video conversion as 
necessary.

`

:

Select this for 1080p output at 24 frames per second.

`

Select this for an output resolution four times that of 
1080p. Depending on the resolution supported by 
your TV, it will result in either 3840 × 2160 or 4096 
× 2160 pixels.

`

Source:

Select this for an output following the resolution level 
set in “Picture Adjust” (

“Setup”

Composite video, 

component video

HDMI

HDMI

Composite video, 

component video

Composite video

Composite video

Component video

Component video

The current setting is displayed.

`

Analog, HDMI Main, HDMI Sub or Both.