Справочник Пользователя для ONKYO TX-NR5010

Here you can check the settings made by 
Audyssey MultEQ XT32 Room Correction and Speaker 
Setup function, or set them manually, which is useful if 
you change one of the connected speakers after using 
Audyssey MultEQ XT32 Room Correction and Speaker 
Setup function.
Press RECEIVER and use SP on the remote controller to 
select Speakers A or Speakers B. For details on SP, see 
“Selecting Speaker Layout” (

).

• These settings are not available in either of the following cases:

– a pair of headphones is connected.
– the  “Audio TV Out” setting is set to “On” (

).

– “HDMI Control(RIHD)” is set to “On” (

you’re listening through your TV speakers.

If the impedance of any speaker is 4 ohms or more but less 
than 6, set the minimum speaker impedance to 4 ohms.
If you bi-amp the front speakers, you must change the 
“Speakers Type(Front A)” or “Speakers 
Type(Front B)” setting. For details on speaker wire 
connection, see “Bi-amping the Front Speakers” 
(

). When connecting speakers without 

crossover network, you need to change the “Speakers 
Type(Front A)” or “Speakers Type(Front B)” setting 
beforehand. For details on connection, refer to “Using 
Speakers Without Crossover Network” (

).

• When bi-amping is used, the AV receiver is able to drive up to 7.2 

speakers in the main room.

• Before you change these settings, turn down the volume.

■

`

4ohms:

Select if the impedance of any speaker is 4 ohms or 
more but less than 6.

`

6ohms:

Select if the impedances of all speakers are between 6 
and 16 ohms.

■

`

:

Select this if you’ve connected your front speakers A 
normally.

`

Bi-Amp:

Select this if you’ve bi-amped your front speakers A.

`

Digital Crossover:

Select this if you’re using speakers without crossover 
network.

■

`

No:

Select this if you’re not using speakers B.

`

Normal:

Select this if you’ve connected your front speakers B 
normally.

`

Bi-Amp:

Select this if you’ve bi-amped your front speakers B.

`

Digital Crossover:

Select this if you’re using speakers without crossover 
network.

• If “Speakers Type(Front A)” or “Speakers Type(Front B)” is 

set to “Digital Crossover”, a confirmation screen appears. Select 
“Next (2-7. Digital Processing Crossover Network)” to display 
the screen for Digital Processing Crossover Network 
(

). Continue with the settings.

■

`

No 

`

Yes:

Zone 2/3 speakers can be used. (Powered Zone 2/3 
enabled).

■

`

No 

`

For 11.2-channel playback, set this setting to “Yes”. If you 
select front wide speakers setting in Speaker Configuration 
is set to “None”, it will be automatically switched to 
“80Hz (THX)”.

Some of the settings in this section are set automatically 
by Audyssey MultEQ

®

XT32 Room Correction and 

Speaker Setup function (

). For Speakers B, 

you need to change the settings manually.

“Setup”