Справочник Пользователя для ONKYO TX-NR5010

■

`

0º 

`

180º:

With this setting, you can adjust the phase of tweeters and 
woofers.

• Sounds processed by Digital Processing Crossover Network are 

played.

• You can switch from the current audio source to test noises by 

pressing  MODE/D (Blue).

■

`

0inch(0.0cm) to 12inch(30.0cm) in 1 inch (2.5 cm) 
steps.

With this setting, you can adjust the virtual position of 
tweeter and woofer units. Adjusting “High Distance” 
virtually shifts woofers behind tweeters. Adjusting “Low 
Distance” virtually shifts tweeters behind woofers.

• Sounds processed by Digital Processing Crossover Network are 

played.

• You can switch from the current audio source to test noises by 

pressing  MODE/D (Blue).

With the Audio Adjust functions and settings, you can 
adjust the sound and listening modes as you like.

■

`

Main 

`

`

This setting determines which channel of a stereo 
multiplex source is output. Use it to select audio channels 
or languages with multiplex sources, multilingual TV 
broadcasts, and so on.

■

`

Left + Right 

`

`

This setting specifies the channel to be used for playing 
any 2-channel digital source such as Dolby Digital, or 2-
channel analog/PCM source in the Mono listening mode.

`

Center:

Mono audio is output by the center speaker.

`

Left / Right:

Mono audio is output by the front left and right 
speakers.

This setting determines which speakers output mono audio 
when the Mono listening mode is selected.

• If the “Center” setting is set to “None” (

cannot be selected.

■

These settings apply to only 2-channel stereo sources.
If you’re not using any surround back speakers, these 
settings apply to Dolby Pro Logic II, not Dolby Pro Logic 
IIx.

`

`

Off 

With this setting, you can broaden the width of the front 
stereo image when using the Dolby Pro Logic IIx Music 
listening mode.

`

–3 to 0 to +3

With this setting, you can move the sound field forward or 
backward when using the Dolby Pro Logic IIx Music 
listening mode. Higher settings move the sound field 
backward. Lower settings move it forward.
If the stereo image feels too wide, or there’s too much 
surround sound, move the sound field forward to improve 
the balance. Conversely, if the stereo image feels like it’s 
in mono, or there’s not enough surround sound, move it 
backward.

(Low Distance)

Tweeter

Woofer

(High Distance)

Distance

Distance

“Setup”