Справочник Пользователя для ONKYO TX-NR5010

■

Enter the DNS server address provided by your ISP.

■

To use a Web proxy, enter its URL here.

■

If you’re using a Web proxy, enter a proxy port number 
here.

■

`

`

Off 

This setting enables or disables control over the network.
When enabled, the NET indicator will be dimly-lit while 
the AV receiver is in standby mode. Note that the indicator 
may not light under certain conditions (

• When set to “On”, the power consumption slightly increases in 

standby mode.

■

`

Enable 

`

When this setting is enabled, you will be notified if a 
firmware update via network is available.

• Selecting “Never Remind me” on the notification window will 

switch this setting to “Disable” (

).

• For details on the update notification, see “If the “Firmware 

If you skipped the initial setup wizard, for example on 
first-time use, you can reaccess it from here.
See “Initial Setup” (

■

`

1, 2, or 3

When several Onkyo components are used in the same 
room, their remote ID codes may overlap. To differentiate 
the AV receiver from other components, you can change 
its remote ID from “1”, to “2” or “3”.

• If you do change the AV receiver’s remote ID, be sure to change 

the remote controller to the same ID (see below), otherwise, you 
won’t be able to control it with the remote controller.

See “Looking up for Remote Control Codes” 
(

).

With this preference, you can protect your settings by 
locking the setup menus.

■

`

`

Unlocked 

When “Locked” is selected, the setup menus will be 
locked and you cannot change any setting.

Use the number buttons to enter ID 1, 2, or 3.
RECEIVER flashes twice.

“Setup”

“Setup”