Справочник Пользователя для ONKYO HT-R510

24

Before connecting the power cord, connect all your speakers 
and AV components (see page 10 to page 23).

With this function you can assign AV components (i.e., input 
sources) with digital audio outputs to the HT-R510’s digital 
inputs. You only need to change these assignments if your 
connections don’t match the default assignments listed in the 
following table. 

If, for example, you connect your DVD player’s optical dig-
ital audio output to the HT-R510’s OPTICAL 1 DIGITAL 
INPUT, you’ll need to change the DVD input source assign-
ment from COAXIAL to OPTICAL 1.

You can change the assignments as follows.

If you’ve connected a MiniDisc recorder to the TAPE 
inputs, you can set the HT-R510 so that “MD” appears on 
the display instead of “TAPE.” Simply press and hold the 
[TAPE] button until “MD” appears (about two seconds).

Notes:
• For AV components that are connected to only analog 

inputs, choose the “– – – –” setting.

• If you don’t press the [DIGITAL INPUT] button for three 

seconds, the previous display reappears.

• You can also specify a signal format for the DIGITAL 

INPUTs (page 28).

Turning on the HT-R510 may cause a 
momentary power surge that might inter-
fere with other electrical equipment on 
the same circuit. If this is a problem, plug 
the HT-R510 into a different branch cir-
cuit.

The HT-R510 comes on, the display 
lights up, and the STANDBY indicator 
goes off.

To turn off the HT-R510, press the 
[STANDBY/ON] button. The HT-R510 
will enter Standby mode. To prevent any 
loud surprises the next time you turn on 
your HT-R510, always turn down the vol-
ume before turning it off.

COAXIAL

Not assigned

OPTICAL 2

Not assigned

Not assigned

OPTICAL 1

The selected source appears on the dis-
play. (The value next to the input source is 
the volume setting.)

The current source assignment appears, as 
shown.

See page 28 for information on playing your AV compo-
nents through the HT-R510.

To get the most out of your HT-R510, you should also set 
the functions on pages 25 through 27.