Справочник Пользователя для ONKYO HT-RC370

En

page 67).

With this preference, you can protect your settings by 
locking the setup menus.

■

`

`

When “Locked” is selected, the setup menus will be 
locked and you cannot change any setting.

You can change various audio settings from the Home 
menu (

page 40).

• These settings are not available in either of the following cases:

– a pair of headphones is connected.
– the  “Audio TV Out” setting is set to “On” (

page 58).

– “HDMI Control(RIHD)” is set to “On” (

page 57) and 

you’re listening through your TV speakers.

■

`

–10dB to 0dB to +10dB in 2 dB steps.

You can boost or cut low-frequency sounds output 
from the front speakers.

■

`

–10dB to 0dB to +10dB in 2 dB steps.

You can boost or cut high-frequency sounds output 
from the front speakers.

You can adjust the bass and treble for the front speakers, 
except when the Direct, Pure Audio or THX listening 
mode is selected.

• To bypass the bass and treble tone circuits, select the Direct, 

Pure Audio or THX listening mode.

• This setting is not available when the multichannel Analog input 

is selected.

■

`

–15.0dB to 0.0dB to +12.0dB in 0.5 dB steps.

■

`

–12.0dB to 0.0dB to +12.0dB in 0.5 dB steps.

You can adjust the volume of each speaker while listening 
to an input source.
These temporary adjustments are cancelled when the AV 
receiver is set to standby. To save the setting you made 
here, go to “Level Calibration” (

setting the AV receiver to standby.

• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” or “None” in 

page 46) cannot be adjusted.

■

See “Dolby Volume” of “Audio Adjust” (

page 50).

• This setting cannot be used in either of the following cases:

– Pure Audio or Direct listening mode is selected.
– the multichannel analog input is selected.
– any of the THX listening modes is selected, with “Loudness 

Plus” set to “On” or “Preserve THX Settings” set to “Yes” 
(

page 49).

• When  “Dolby Volume” is set to “On”, the “Dynamic EQ” and 

“Dynamic Volume” settings of all input selectors are switched 
to “Off”.

q/w and ENTER to select “Audio”, and then 

q/w/e/r to make the desired selection.