Справочник Пользователя для Marantz SR8200

With Dolby Digital and DTS , not only the LFE (Low Frequency
Effects), but also the bass of all channels can be heard from the
Subwoofer or Large-speakers. This procedure prevents these
speakers from becoming too loud and creating an unbalanced sound.
Since the sound is output at a loud volume, perform this operation
carefully.

• If your system does not include a subwoofer, this setting will set

the bass peak level for your front speakers.

Press the 

or 

button, START is indicated and

it begins to generate a Bass test tone from the
speaker which was designated “bass signal output”
during setup.
There will be no audible sound yet because the
Master volume is set to minimum automatically.
Press 

cursor button to move the cursor to

VOLUME control.

Adjust the bass test tone output level up until the
bass begins to distort or you reach the maximum
level with the 

, 

or  

/ 

cursor

button.
Press 

cursor button to move the cursor to

ENTER.

Press the 

button, ENTER will blink and stop

generating the Bass Peak test tone.
The Bass Peak Limit Level for your system has now
been memorized.

If you finish these setup, move cursor to “MAIN” with 

 or 

cursor button and then press 

 button to go to MAIN menu.

• Each time the subwoofer level is changed, perform the Bass

Peak Level setup and correct the setting.

• The bass peak level is not available in SOURCE-DIRECT and

7.1CH-INPUT mode.

• The selected value is displayed in the volume column before the

test signal starts.

Select  “

” in MAIN 

 with 

 or 

cursor button, and press the 

button.

To select a desired content, press 

 or 

 cursor button.

Select the TV AUTO ON/OFF function to enable or
disable with 

or 

cursor button.

(refer to page 39)

Select the OSD information function to enable or
disable with 

or 

cursor button.

If you select “

”, SR8200 will display the status

of the feature (Volume up/down, input select, etc..) on
the TV monitor. But if you do not desire this
information, select “

“.

Select the digital source to output the DIGITAL OUT
terminals with 

or 

cursor button.

This is for digital dubbing to a CD-R recorder or MD
deck. (See page 45)
The source is switched in the following sequence.
SOURCE 

→

DIG.1 

→

DIG.2 

→

 

→

 

→

DIG.8 

→

DIG.9 

→

AUX 

→

OFF 

→

SOURCE 

→

position is required, but If you desire an

additional front L/R mixed subwoofer output in the
STEREO mode, select 

with 

or 

button.

If you finish the setup in this item, move cursor to “

” with 

 or

cursor buttons and press 

button.