Справочник Пользователя для RCA Stereo Receiver with Remote Control
8
INSTALLING BATTERIES
Cautions:
• Use only fresh batteries of the required size and recommended
type.
• Do not mix old and new batteries, different types of batteries
(standard, alkaline, or rechargeable), or rechargeable batteries of
different capacities. Your remote control requires two AA
batteries (not included) for power. For the best operation and
longest life, we recommend alkaline batteries, available at your
local RadioShack store.
different capacities. Your remote control requires two AA
batteries (not included) for power. For the best operation and
longest life, we recommend alkaline batteries, available at your
local RadioShack store.
1. To remove the battery compartment cover, push the
compartment’s tab in the direction of the arrow, then lift off the
cover.
cover.
2. Place two fresh AA batteries in the compartment as indicated by
the polarity symbols (+ and –) marked inside.
3. Replace the battery compartment cover.
When the range is reduced or the remote stops operating properly,
replace the batteries.
replace the batteries.
Warning: Dispose of old batteries promptly and properly. Do not
burn or bury them.
burn or bury them.
Caution: If you do not plan to use the remote with batteries for a
month, remove the batteries. Batteries can leak chemicals that can
destroy electronic parts.
month, remove the batteries. Batteries can leak chemicals that can
destroy electronic parts.
CONNECTING TO AC POWER
Warning: To prevent electric shock, do not use this polarized plug
with an extension cord, receptacle, or other outlet unless you can
fully insert the blades to prevent blade exposure.
with an extension cord, receptacle, or other outlet unless you can
fully insert the blades to prevent blade exposure.
Before you plug in the receiver’s power cord, double check all other
connections.
connections.
To power the receiver, plug the supplied power cord into a standard
AC outlet. The power cord’s plug is polarized and fits only one way.
AC outlet. The power cord’s plug is polarized and fits only one way.
The STAND BY indicator lights when the receiver is plugged in but
turned off.
turned off.
Note: The receiver has a built-in circuit to protect it against
overheating or short circuits. If your receiver automatically turns off
(stand by mode), let it cool for several minutes. If the receiver
overheated, it should play normally when you turn it back on. If
there is a short circuit in your receiver, it will turn off again when you
turn on the receiver. If this happens, check with your local
RadioShack store for service.
overheating or short circuits. If your receiver automatically turns off
(stand by mode), let it cool for several minutes. If the receiver
overheated, it should play normally when you turn it back on. If
there is a short circuit in your receiver, it will turn off again when you
turn on the receiver. If this happens, check with your local
RadioShack store for service.