Справочник Пользователя для RCA RV-9968
21
using the universal remote control
PROGRAMMING THE REMOTE
TO CONTROL A DVD PLAYER
TO CONTROL A DVD PLAYER
The remote is preprogrammed to control a RCA DVD
player. A few of the remote buttons used with a DVD
player are shown below. You may want to experiment
with other buttons on the remote to see if they work
with your DVD player.
player. A few of the remote buttons used with a DVD
player are shown below. You may want to experiment
with other buttons on the remote to see if they work
with your DVD player.
Receiver Remote
(works like)
DVD Remote
INFO INFO
GO BACK GO BACK
CLEAR CLEAR
CLEAR CLEAR
MENU SELECT MENU SELECT
MOVE Arrows ARROWS
PLAYLIST PLAYLIST
ENTER ENTER
Programming the Remote
to Control an RCA brand DSS
to Control an RCA brand DSS
®
Receiver
The remote is preprogrammed to control the RCA
brand DSS
brand DSS
®
receiver. A few of the remote buttons used
with the RCA brand DSS
®
receiver are shown below.
You may want to experiment with other buttons on
the remote to see if they work with your receiver.
the remote to see if they work with your receiver.
Receiver Remote (works like)
RCA brand DSS
®
Remote
INFO SELECT/DISPLAY
GO BACK PREV CH
ANTENNA TV/SAT
CLEAR CLEAR
MENU/SELECT MENU
MOVE ARROWS ARROWS
DSS
®
is a registered trademark of DIRECTV, INC., a unit of GM Hughes Electronics.
This remote may not operate all models of the
brands shown.
brands shown.
If a battery is removed from the battery
compartment of the remote control, all control key
functions will return to the original mode.
compartment of the remote control, all control key
functions will return to the original mode.
To program the LD•VCR2 button to control a second
VCR, follow these steps but use the LD•VCR2 button
instead of the VCR button.
VCR, follow these steps but use the LD•VCR2 button
instead of the VCR button.
The buttons on the remote may not work on all
other brands of components. Experiment with the
remote and your components to see which buttons
work.
other brands of components. Experiment with the
remote and your components to see which buttons
work.
Programming the Remote
to Control A Satellite RECEIVER
to Control A Satellite RECEIVER
1.
Turn on the satellite receiver.
2.
Look up the satellite receiver brand and
corresponding code number(s) in the code list on
the right.
corresponding code number(s) in the code list on
the right.
3.
Press and hold the SAT•CABLE button on
the remote.
the remote.
4.
Enter the three-digit code from the code list.
5.
Release the SAT•CABLE button, then press POWER
or CH + or CH – to see if the receiver responds to
the remote’s commands. If it doesn’t, try pressing
SAT•CABLE, then POWER again.
or CH + or CH – to see if the receiver responds to
the remote’s commands. If it doesn’t, try pressing
SAT•CABLE, then POWER again.
6.
Repeat steps 3 through 5 using the next code listed
for the brand of your receiver until the receiver
responds to the remote commands.
for the brand of your receiver until the receiver
responds to the remote commands.