Справочник Пользователя для TEAC AG-H380

AG-H380’s red speaker terminals are the + (positive) terminals 
and the black terminals are the _ (negative) terminals.
The  +   side  of  the  speaker  cable  is  marked  to  make  it 
distinguishable  from  the  negative  side  of  the  cable.  Connect 
this marked side to the red + terminal and the unmarked side 
to the black _ terminal of AG-H380 and speakers.

<  To avoid damaging the speakers by a sudden high-level signal, 

be sure to switch the power off before connecting the speakers.

<  Check  the  impedance  of  your  speakers.  Connect  speaker  with 

an impedance of 6 ohms or more.

<  Prepare  the  speaker  cords  for  connection  by  stripping  off 

approximately  10  mm  or  less  (no  more  as  this  could  cause  a 
short-circuit)  of  the  outer  insulation.  Twist  the  wires  tightly 
together to avoid tangles:

How to connect
1. Turn  the  terminal  cap  counter-clockwise  to  loosen  it.  The 

speaker terminal caps cannot be fully removed from the base.

2. Insert  the  wire  into  the  terminal  fully  and  turn  the  terminal 

cap clockwise to securely connect it:

3. Make sure it is fastened firmly by pulling the cable lightly.

For European customers
In  accordance  with  European  safety  regulations,  it  is  not 
possible to connect banana plugs into the speaker terminals on 
European models.
The  holes  into  which  banana  plugs  are  inserted  have  been 
covered with black caps. Connect the speakers using spades or 
bare wires.
If  the  black  caps  become  separated  from  the  terminals,  return 
them to their original position.

Connect a commercially available powered subwoofer.

If  you  have  TEAC  Reference  380  series,  convenient  system  control 
operations and AI direct play functions are possible.

<  By  pressing  the  POWER  switch  of  AG-H380,  you  can  switch  ON/

standby all the unit connected by remote control cords.

  (Set  the  REMOTE  CONTROL  SELECTOR  on  the  rear  panel  of  the 

PD-H380 to “SYSTEM”.)

<  When  you  press  the  PLAY  button  of  PD-H380,  the  source  of 

AG-H380 is set to “CD” automatically.

<  When  you  select  “CD”  by  pressing  the  SOURCE  button  of 

AG-H380, PD-H380 starts playback automatically.

<  When you turn on the system, the source that was selected last 

time will start playback automatically.

<  You  can  use  the  system  remote  control  unit  to  operate  all  the 

unit connected by remote control cords.