Справочник Пользователя для Profile HA1000
12
NON-POLAR
CAPACITOR
INDUCTOR
(COIL)
L
E
G
E
N
D
Left
Mid / Tweeter
4 Ohm
(2 Ohm Minimum)
Mono Woofer
8 Ohm
(4 Ohm Minimum)
Right
Mid / Tweeter
4 Ohm
(2 Ohm Minimum)
¹
F
100
¹
F
100
CAUTION! In Tri- mode operation, the amplifier must see a 2 Ohm load or higher for the
stereo satellites and no lower than 4 Ohms for the subwoofer(s).
Any lower than the above mentioned impedance will cause internal damage
to the amplifier.
Any lower than the above mentioned impedance will cause internal damage
to the amplifier.
S
PEAKER CONNECTIONS (TRI-MODE)
All 2 channel amplifiers are capable of running both in Mono & Stereo mode. This feature
gives the amplifier the ability to run stereo satellites (midbass & tweeter) simultaneously
with a mono subwoofer.
gives the amplifier the ability to run stereo satellites (midbass & tweeter) simultaneously
with a mono subwoofer.
These connections are more complicated because they require the use of passive crossover
networks (Not provided) to divide the frequencies to the speakers. We have included a sample
diagram for 4 Ohm connections. If you wish to use multiple speakers to achieve a lower
impedance and higher power, it is strongly recommended that you seek professional advice
from your Profile retailer before attempting to make these connections.
networks (Not provided) to divide the frequencies to the speakers. We have included a sample
diagram for 4 Ohm connections. If you wish to use multiple speakers to achieve a lower
impedance and higher power, it is strongly recommended that you seek professional advice
from your Profile retailer before attempting to make these connections.
Please Note: In the Tri-mode configuration, the amplifier's built-in crossover must be set to
"FULL"(OFF) position.
4
m
H