Справочник Пользователя для Radio Shack XL-110
12
Connecting Inputs
CONNECTING SPEAKERS
You can connect two speakers or a subwoof-
er to the amplifier and your auto sound sys-
tem.
er to the amplifier and your auto sound sys-
tem.
• If you are connecting two speakers, fol-
low Steps 1–3 under “Preparing the
Speaker Wires” then see “Connecting
Two Speakers” on Page 13 to connect
the speakers to the amplifier.
Speaker Wires” then see “Connecting
Two Speakers” on Page 13 to connect
the speakers to the amplifier.
• If you are connecting a subwoofer, follow
Steps 1–3 under “Preparing the Speaker
Wires” then see “Connecting a Sub-
woofer” on Page 13 to connect a sub-
woofer to the amplifier.
Wires” then see “Connecting a Sub-
woofer” on Page 13 to connect a sub-
woofer to the amplifier.
Preparing the Speaker Wires
Caution: You must connect a separate wire
to each speaker terminal as described in the
following procedures. Unless your auto
sound system’s speakers use a common
ground wire, do not use a common wire or
chassis ground for speaker connections.
to each speaker terminal as described in the
following procedures. Unless your auto
sound system’s speakers use a common
ground wire, do not use a common wire or
chassis ground for speaker connections.
Notes:
• We recommend you use 16- or 18-
gauge marked or color-coded wires to
help you correctly connect the speakers
to your amplifier.
help you correctly connect the speakers
to your amplifier.
• Color-coded wires have a stripe running
down one of the conductors or different
colored insulation for each conductor.
Your local RadioShack store has a wide
selection of speaker wire to choose
from.
colored insulation for each conductor.
Your local RadioShack store has a wide
selection of speaker wire to choose
from.
• For the maximum bass response and
the best overall performance, keep your
speakers properly phased (connect + to
+ and – to –).
speakers properly phased (connect + to
+ and – to –).
1. With the speakers placed in their
approximate locations, run one wire
from each speaker to the amplifier.
from each speaker to the amplifier.
2. Separate each wire’s two conductors at
both ends for a length of about 4 inches.
3. Strip the insulation from the ends of
each conductor to expose
1
/
4
inch of
wire. Twist the ends to secure loose
strands.
strands.
4 Inches
Conductors
1
/
4
Inch
12-2014.fm Page 12 Tuesday, May 9, 2000 8:51 AM