Справочник Пользователя для Musical Fidelity X-80

Issue 4  May 2004

(U.K. only)

This unit is supplied in the U.K. with a mains lead fitted with a moulded 13 amp plug.

If, for any reason, you need to cut off this plug, please remove the fuse holder and dispose
of the plug safely, out of reach of children.  

It must not be plugged into a mains outlet.

The wires in the mains lead supplied with this appliance are coloured in accordance

with the following code:

Green and yellow..............Earth
Blue...............................Neutral
Brown................................Live

As the colours of the wires of the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured green-and-yellow must be connected to the terminal in the plug
which is marked with the letter E or coloured green or green-and-yellow, or by the earth

The wire which is coloured brown must be connected to the terminal which is marked with
the letter L or coloured red.

The wire which is coloured blue must be connected to the terminal which is marked with
the letter N or coloured black.

If connecting to a BS1363 plug, a 13 amp fuse must be used.

Plug the accessory IEC mains lead into the
rear panel socket, then the other end into a
wall outlet.

Turn the volume control on the front panel
to minimum (anticlockwise).

STARTING . . . .

Press the 

POWER button on the X-80

amplifier - the blue power LED on the
front panel will light indicating that the
unit is ready for use.  However, for about
six seconds no sound will be heard from
your speakers, and the red mute LED will
be lit, confirming initial mute action.

Select the required audio input source by
pressing the 

< or 

> function button on the

front panel one or more times.

Alternatively, direct access can be obtained
by pressing buttons 1, 2, 3 or 4 on the
remote control.  In either case, a correspon-
ding blue indicator LED on the front panel
will light to confirm your choice.

Now adjust the volume control to obtain
the preferred sound level.

To record, simply select the required
source with the up or down input selector
button on the front panel, or directly from
the remote control.  This source will now
be routed to the X-80’s 

output for recording by the external tape
deck.
You will still also be able to hear the
selected source through the loudspeakers.

Note - adjustment of the volume control
has no effect on the recording level.