Справочник Пользователя для Emotiva IPS-1
Page 22
Page 23
Surround Back Speakers
Many preamplifier processors feature additional outputs for surround back speakers. These create a
wonderful sense of realism in surround effects during playback of Dolby Digital EX, Dolby Pro Logic
IIx, and DTS ES.
Many preamplifier processors feature additional outputs for surround back speakers. These create a
wonderful sense of realism in surround effects during playback of Dolby Digital EX, Dolby Pro Logic
IIx, and DTS ES.
Ideally, all the surround speakers should be of the same make and model as the surround speakers,
and fitted at similar heights to produce a smooth continuous sound field.
and fitted at similar heights to produce a smooth continuous sound field.
Subwoofer Location
Although subwoofers are normally configured with their
own internal power amplifier (rather than using the IPS-1),
we know you will probably use at least one subwoofer in
your home entertainment system. As such, it’s important to
understand correct subwoofer placement so that you get
the most out of the other speakers connected to the IPS-1
Modular Power Amplifier.
own internal power amplifier (rather than using the IPS-1),
we know you will probably use at least one subwoofer in
your home entertainment system. As such, it’s important to
understand correct subwoofer placement so that you get
the most out of the other speakers connected to the IPS-1
Modular Power Amplifier.
A subwoofer typically sounds best in a corner with at least
5 feet of wall to either side. Due to the short wavelengths
of high-frequency sounds, they don’t interact strongly with
the size and shape of a room. Lower frequencies long wave-
lengths that can cause “Standing wave” problems. Placing
the subwoofer in a corner usually creates the best possible
situation for the sound to interact with the room, allowing
5 feet of wall to either side. Due to the short wavelengths
of high-frequency sounds, they don’t interact strongly with
the size and shape of a room. Lower frequencies long wave-
lengths that can cause “Standing wave” problems. Placing
the subwoofer in a corner usually creates the best possible
situation for the sound to interact with the room, allowing
even distribution of the bass frequencies. Often the corner that offers nearby placement to the
front speakers may yield the best results, but you should try several locations before settling on
just one.
front speakers may yield the best results, but you should try several locations before settling on
just one.
The best location for a single subwoofer can be found by playing a couple of different low frequency
test tones (or some music with heavy sustained bass passages) and proceeding with the following
easy 1-2-3 process:
test tones (or some music with heavy sustained bass passages) and proceeding with the following
easy 1-2-3 process:
1. Place the subwoofer right on the seat of your couch or listening chair.
2. You can then either run the calibration (noise) signal through it, or simply plug the analog outputs of a
2. You can then either run the calibration (noise) signal through it, or simply plug the analog outputs of a
CD player directly into your subwoofer’s low-level inputs. Turn down the subwoofer’s volume level before
turning on the CD, then play the test tones or some music with heavy sustained bass passages.
turning on the CD, then play the test tones or some music with heavy sustained bass passages.
3. Walk around the room, standing in all the positions where you might be able to place the subwoofer.
Again, this is usually near the corners of the room. Try locations fairly close to the front speakers.
Standing waves depicted in a room.
“Peaks” are good, “Dips” are bad.