Справочник Пользователя для Chauvet 360Z-LED
Setup
-6-
Q-Wash 360Z-LED User Manual Rev. 01g
3. Setup
AC Power
The Q-Wash 360Z-LED has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
voltage range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the
specifications in this guide, the product’s user manual, or on the product’s sticker.
specifications in this guide, the product’s user manual, or on the product’s sticker.
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
ground to avoid the risk of electrocution or fire.
To determine the power requirements for the Q-Wash 360Z-LED see the label affixed to
the side of the fixture. Alternatively, you may refer to the Technical Specifications chart in
the Technical Information chapter of this manual.
the side of the fixture. Alternatively, you may refer to the Technical Specifications chart in
the Technical Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation. For
more information, you may download the “Sizing the Circuit Breakers” document from the
CHAUVET® Web site.
more information, you may download the “Sizing the Circuit Breakers” document from the
CHAUVET® Web site.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
the rheostat or dimmer channel serves only as a 0 to 100% switch.
AC Plug
The Q-Wash 360Z-LED comes with a power input cord terminated with an IEC connector
on one end an Edison plug on the other end (US market). If the power input cord that came
with your product has no plug or you need to change the Edison plug, use the table below
to wire the new plug.
on one end an Edison plug on the other end (US market). If the power input cord that came
with your product has no plug or you need to change the Edison plug, use the table below
to wire the new plug.
Connection
Wire (US)
Wire (Europe)
Screw Color (US)
AC Live
Black
Brown
Yellow or Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
Make sure to disconnect the fixture’s power cord before replacing a blown fuse, and
always replace it with a fuse of the same type and rating.
always replace it with a fuse of the same type and rating.
Fuse Replacement
1) Wedge the tip of a flat head screwdriver into the slot of the fuse holder and pry it out of
its housing.
2) Remove the blown fuse from its holder and replace it with a fuse of the exact same
type and rating (T 5 A, 250 V).
2) Insert the fuse holder back in its place, and reconnect power.
The fuse is located
inside this compartment.
Remove it using a flat
head screwdriver.
inside this compartment.
Remove it using a flat
head screwdriver.