Справочник Пользователя для Dynaudio Focus

2. Connect the other cable ends to the loudspeaker outputs of your switched off power 

amp (see Fig. 2).

Note
Please make sure that the red marked post of the speaker is connected to the red 
marked output of the amp, and the white or black marked post to the white or black 
marked output accordingly.

Dynaudio loudspeakers feature a carefully fine-tuned cross-over, optimized using 
selected parts and an advanced circuitry to achieve a truly balanced and smooth 
frequency response. Therefore, dividing the frequency sections through bi-wiring or 
bi-amping is neither beneficial nor optional.

The impact a loudspeaker cable can have on sound quality may be dramatic, though in 
general quality cable products will yield a quality result.
Dynaudio loudspeakers are designed to be very neutral and thus are not extremely suited 
to any particular type of cable. The choice of cable is as much a factor of matching the 
cable to the entire audio system. Please consult your Dynaudio dealer for information 
about compatible loudspeaker cables that will suit both your electronics and the Focus 
loudspeakers.

When connecting a two-channel stereo system, only the right and left channels are 
connected to the amplifier.
In a surround set-up, center, side or rear loudspeakers as well as a subwoofer are 
typivally connected to provide for a multi-channel listening experience. Please refer to the 
amplifier’s owner manual for particular connection instructions and see chapter “Multi-
channel loudspeaker setup” on page 10 for further help.