Справочник Пользователя для Sunfire SRS210W-B

User's Manual

Wiring

1. Install the speaker wires following

all local codes for electrical wiring

installation. Use class 2 wiring,

and 12 gauge is recommended, 16

gauge is the minimum.

2. Follow common low voltage

practices like avoiding high voltage

electrical wiring, or crossing them

perpendicularly. This will reduce the

chance of picking up hum or other

interference.

. Make the speaker wire connec-

tions to the subwoofer terminal cup,

observing the correct polarity. The

terminals are spring-loaded.

4. Secure the wire to the studs with

electrical staples to prevent rattles

and movement in operation.

5. Do an electrical continuity test to

make sure the connections are

good from the amplifier-end of the

speaker wire to the ends of the

two pre-installed wires coming out

from the inside of the subwoofer.

Temporarily remove the cardboard

debris shield to reach the wires.

6. Use caulk to seal the nearest cable

holes to the cabinet. This will pre-

vent air movement and secure the

cables in place. Due to the nature

of subwoofers, it is a good idea to

secure the wiring from vibration as

much as possible. Do not have the

weight of the cables hanging on the

terminals.

Wiring

11

Connecting speaker
wire to the subwoofer

Close-up of the spring-loaded
connections

caulk