Справочник Пользователя для Rel Acoustics Strata 5
REL Acoustics ST 5 User Manual
13
To connect to the amplifier/processor/receiver using the phono to phono
LFE interconnect
LFE interconnect
Alternative method for connecting at Low Level from pre amplifier
In some circumstances it is not possible to use the high level method of connection, for
example when using active speakers. Instead of using the attenuator as shown on page 15,
connect as shown below using a “Y” adapter from the left and right pre amplifier outputs and a
single phono to phono interconnect from the “Y” adapter to one of the low level inputs on the
REL.
Only use this method if the pre amplifier has two separate outputs.
In the unlikely event that the second pre amplifier output is only a parallel connection to the
other then this method will cause a mono signal to be sent to the main amplifier(s) or active
speakers.
example when using active speakers. Instead of using the attenuator as shown on page 15,
connect as shown below using a “Y” adapter from the left and right pre amplifier outputs and a
single phono to phono interconnect from the “Y” adapter to one of the low level inputs on the
REL.
Only use this method if the pre amplifier has two separate outputs.
In the unlikely event that the second pre amplifier output is only a parallel connection to the
other then this method will cause a mono signal to be sent to the main amplifier(s) or active
speakers.
Connect as shown above using a phono to phono interconnect. Plug one end into
the sub/LFE output on the amplifier/processor and the other end into the LFE LEVEL
input on the sub-bass system.
the sub/LFE output on the amplifier/processor and the other end into the LFE LEVEL
input on the sub-bass system.
The output level can be adjusted by one of two methods.
1. By using the remote control: press the buttons marked LFE LEVEL ‘+’ or ‘-‘. The front
control panel will show ‘Hi’ on the two left hand digits. The volume level can be adjusted
up or down by pressing the ‘+’ or ‘-‘ buttons and the display will show 00 to 99 on the two
right hand digits.
up or down by pressing the ‘+’ or ‘-‘ buttons and the display will show 00 to 99 on the two
right hand digits.
2. By using the encoder control on the front control panel: press the control knob to select
‘LF’ on the two left hand digits, rotate control knob to select the value in the range 00 to
99 on the two right hand digits.
99 on the two right hand digits.
Phono to Phono Interconnect.
To sub/LFE output of
Amplifier/Processor
Sub LFE
Input
Input