Справочник Пользователя для JVC RX-6500VBK
4
English
+
+
–
2
1
2
1
–
FRONT SPEAKERS
LEFT
RIGHT
Basic connecting procedure
1 Cut, twist and remove the insulation at the end of
each speaker signal cable (not supplied).
2 Turn the knob counterclockwise.
3 Insert the speaker signal cable.
4 Turn the knob clockwise.
Connecting the front speakers
You can connect two pairs of front speakers (one pair to the FRONT
SPEAKERS 1 terminals, and another pair to the FRONT
SPEAKERS 2 terminals).
SPEAKERS 1 terminals, and another pair to the FRONT
SPEAKERS 2 terminals).
ANTENNA
AM
EXT
AM
LOOP
FM 75
COAXIAL
COAXIAL
2
3
1
Snap the tabs on the loop frame
into the slots of the base to
assemble the AM loop.
into the slots of the base to
assemble the AM loop.
Turn the loop antenna until you have the best reception.
Notes:
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. This could cause poor
reception.
reception.
• If reception is poor, connect an outdoor single vinyl-covered wire to
the AM EXT terminal. (Keep the AM loop antenna connected.)
Connecting the Speakers
You can connect the following speakers:
• Two pairs of front speakers to produce normal stereo sound.
• One pair of rear speakers to enjoy the surround effect.
• One center speaker to produce more effective surround effect (to
• Two pairs of front speakers to produce normal stereo sound.
• One pair of rear speakers to enjoy the surround effect.
• One center speaker to produce more effective surround effect (to
emphasize human voices).
• One subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker
setting information properly to obtain the best possible DSP
effect. For details, see page 12.
setting information properly to obtain the best possible DSP
effect. For details, see page 12.
For each speaker (except for a subwoofer), connect the (–) and (+)
terminals on the rear panel to the (–) and (+) terminals marked on
the speakers. For connecting a subwoofer, see page 5.
terminals on the rear panel to the (–) and (+) terminals marked on
the speakers. For connecting a subwoofer, see page 5.
1
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
speaker terminals.
AM Antenna Connections
2
Outdoor single vinyl-covered wire
AM Loop Antenna
(not supplied)
RIGHT
1
RIGHT
1
RIGHT
1
3
4
FRONT SPEAKERS
1
Left speaker
Right speaker
FRONT SPEAKERS
2
Left speaker
Right speaker
RIGHT
LEFT
CENTER
SPEAKER
REAR
SPEAKERS
Connecting the rear and center speakers
Connect rear speakers to the REAR SPEAKERS terminals and a
center speaker to the CENTER SPEAKER terminals.
center speaker to the CENTER SPEAKER terminals.
Right rear
speaker
Left rear
speaker
Center speaker
EN01-07.RX-6500V[J]
99.12.16, 1:17 PM
4