Справочник Пользователя для ONKYO HT-S990THX

 

18

 

For detailed information, see the pages in parentheses.

 

A

 

Red:

 Subwoofer in standby mode

Green:  Subwoofer on

With the Auto Standby function, the SKW-940 
automatically turns on when an input signal is 
detected in Standby mode. When there’s no input 
signal for a while, the SKW-940 automatically 
enters Standby mode.

 

B

 

This control is used to adjust the volume of the sub-
woofer.

 

C

 

This RCA input should be connected to the sub-
woofer pre out on the AV receiver with supplied 
RCA cable.

 

D

 

Press this switch to the ON position to turn on the 
power. Press it to the OFF position to turn off the 
power.

 

The Auto Standby function turns the subwoofer on when 
the input signal exceeds a certain level. If the Auto 
Standby function does not work reliably, try slightly 
increasing or decreasing the subwoofer output level on 
the AV receiver (page 54).

1

2

4

3

■ Rear

To AC outlet

■ Front

■ Attaching and detaching the speaker grilles

Front, Center, and Surround speakers have detachable grilles. 
Use the following method to attach or detach the grilles.

1. While holding the bottom edge of the speaker grille with 

your both hands, pull it gently toward you to remove the 
bottom of the grille.

2. In the same way, gently pull the upper edge of the speaker 

grille toward you to remove it from the main unit.

3. To replace the grill, push the projections at the corners 

into the grille plug holes on the speaker cabinet.

Replacement

Removal

HT-S990THX_En.book Page 18 Thursday, April 13, 2006 9:01 AM